KC-P30 Mounting and installation instructions
Installation manual V3.28
26
© KEBA
7) Insert the cable glands (surface-mounted cable insertion) or double-
membrane seals (flush-mounted cable insertion) into the corresponding
cable insertion openings.
The charging station is now ready for installation.
To mount the charging station, proceed as follows:
1) Mark the 4 holes
1 in the designated location on the wall. The supplied
drilling template can be used for this purpose.
Fig.6-14: Drilling template
1 ... Mounting holes 2 ... Cable insertion openings
3 ... Cable holder holes
2) If there is a cable holder, mark the cable holder holes 3 .
3) Drill boreholes and, if necessary, insert anchors in the holes.
1 ... Washer for adjusting 2 ... Rear wall of the charging station
3 ... Washer for nut 4 ... Nut
5 ... Hanger bolt x ... 20 mm
To Next Page
Loading...
