KEENCUT Evolution E2 User Manual

3.4 Set Up 3.4
THIN
THICK
➤
➤
It is essential that the material being cut, whether a thin paper/film or a thick board, is
held securely in the machine during cutting. There is a silicon cord set into the Evolution
E2 Base to grip the underside of the material and two similar grip cords set into the
underside of the Cutter Bar. These should be periodically checked for good condition
and replacements obtained from your Keencut distributor.
There is an integral Levelling Adjustment that enables the full width of the cutter bar to
lay flat on any thickness of material. Place the chosen material under the cutter bar and
release both thumbscrews "
S" the cutter bar will settle to the surface of the new
material. Raise the cutter bar using the lift handle and lower again to ensure correct
alignment and tighten both thumbscrews "
S".
Set the Levelling adjustment knobs to suit paper.
S
S

KEENCUT Evolution E2 Specifications

General

Brand	KEENCUT
Model	Evolution E2
Category	Cutter
Language	English