Need help?Do you have a question about the KEEWAY ARN150 and is the answer not in the manual?
Defines fundamental engine terms like dead center, cylinder diameter, journey, and torque.
Provides essential safety warnings and rules for working in a repair shop environment.
Offers guidelines for safely handling and routing electrical cables to prevent hazards.
Details specific torque values for various fasteners in the engine and transmission system.
Outlines the step-by-step procedures for removing and installing the engine.
Guides the process of installing the cylinder head, including torques and important notices.
Provides detailed instructions for removing and installing piston rings and pistons.
Details the procedure for setting valve clearance, including necessary steps and measurements.
Provides steps to measure cylinder air pressure and diagnose issues based on results.
Provides comprehensive steps for removing, installing, and cleaning the carburetor assembly.
Lists essential inspection procedures to be performed before vehicle delivery.
Outlines periodic maintenance tasks and their recommended intervals based on mileage.
Guides troubleshooting for engine start issues, including fuel and ignition system checks.
Addresses issues like insufficient engine power, speed problems, and overheating.
Troubleshoots low cylinder pressure, speed issues, and carburetor problems.
Covers issues related to high-speed operation, control difficulty, and steering alignment.
Diagnoses fuel system issues and cylinder/valve related problems affecting engine performance.
Addresses driving capability, noise issues, clutch problems, and wheel alignment.
Troubleshoots brake system issues like softness, hardness, and rear wheel alignment.
Covers electrical faults related to battery, starting system, and lighting.
To Next Page
General
