Install the movable driven face seat①.
install the clutch shoe assembly② and nut
③.
tighten the nut③ to the specified torque
with the special tool.
tightening torque：
：：
：40-60 N.M
(4.0-6.0kg.m 29.0-43.5Ib-ft)
insert the V-belt between the driven faces as deep inside
possible while pulling the movable driven face all the way
outside to provide the maximum ble clearance.
CAUTION:
the belt should be positioned so that the arrows on the belt
periphery point the normal turning direction.
The V-belt contact face on the driven faces should be
thoroughly cleaned to be free from oil.
Thoroughly clean the clutch housing to be free from oil and
position it over the clutch shoe assembly.
tighten the clutch housing nut to the specified torque with
the special tool.
Torque：
：：
：40-60 N.M
(4.0-6.0kg.m 29.0-43.5Ib-ft)
To Next Page
Loading...
