KEEWAY Matrix User Manual

98
REASSEMBLY AND REMOUNTING
Reassemble and remount the rear wheel and brake in
the reverse of removal, and also carry out the following steps:
□ Turn the punched mark① on the camshaft to the
Rear axle shaft side.
□ Install the protrusion ② of indicator plate to the groove ③ of
Camshaft.
□ When installing the brake cam shaft, aligh the groove ④ of camshaft
With the slit ⑤ of on cam shaft.
□ When installing brake shoes, be sure to daub camshaft with
Adequate grease.
CAUTION:
Be careful not to daub the camshaft with too much grease.
If grease gets on the lining, brake effectiveness will be lost.

KEEWAY Matrix Specifications

General

Fuel System	Carburetor
Front Suspension	Telescopic fork
Front Brake	Disc
Rear Brake	Drum
Front Tire	120/70-12
Rear Tire	130/70-12
Width	700 mm
Cooling System	Air cooled
Transmission	Automatic