BRAKE CALIPER REASSEMBLY
Reassemble and remount the calliper in the reverse order of removal
and disassembly, and also carry out the following steps.
CAUTION:
Wash the calliper components with fresh brake fluid before reasse-
mbly. Never use cleaning solvent or gasoline to wash them.Apply b-
rake fluid to the calliper bore and piston to be inserted into the bore.
Reassemble and remount the calliper. (refer to preceding bove pages)
WARNING:
Bleed air after remounting the calliper. (refer to above pages)
MASTER CYLINDER REMOVAL AND DISASSEMBLY
Remove the handlebar cover. (Refer to above page)
Disconnect the front brake light switch lead wires.
Place a cloth underneath the union bolt on the master cylinder
to catch spilled drops of brake fluid. Unscrew the union bolt a-
nd disconnect the brake hose master cylinder joint.
CAUTION:
Completely wipe off any brake fluid adhering to any part of motorcycle.
The fluid reacts chemically with paint, plastics, rubber materials, etc.
Remove the master cylinder.
To Next Page
Loading...
Need help?
General
