Insert the spacer④
Position the movable drive face subassembly
on the crankshaft as shown in illustration.
NOTE
：
：：
：
Thoroughly clean the belt contact to be free
from oil.
Install the fixed drive fan①.
tighten the nut to the specified torque with
special tool.
Connecting rod fixer
Tightening torque：40-60N.M
(4.0-6.0kg-m, 29.0-43.5Ib-ft)
fill grease in the groove provided inside
sliding surface of the kick driven gear and
install ② on the end of the crankshaft.
Wipe pff excess grease.
QIANJIANG super grease
Install washer③ and spring④.
NOTE:
When Installing washer
③，
face the resin
surface of washer to outside.
install the retainer⑤.
continue turning the fixed drive face⑥ by hand
until the belt is seated in and both the
drive and driven faces⑦ will move
together smoothly with slip.
To Next Page
Loading...
