42
STANDING HIP
CYLINDER ADJUSTMENT
NOTICE: CYLINDERS ARE FACTORY-ADJUSTED AND REQUIRE NO
FURTHER ADJUSTMENT UNLESS THEY ARE REPLACED. Please contact
KEISER if you have any questions concerning adjustments or repairs.
1. Decrease the resistance to zero.
2. Pull up on the rod until the cam follower touches the cam. With no machine
resistance, check the feel of the movement of the machine. If the rod seems to stick
or hesitate at full extension, the piston may be bottomed-out against the end housing.
If the piston is bottomed-out, lengthen the rod three full turns (pg. 13 maintenance
manual).
EXERCISE ARM BUSHING
1. Oil the brushings by filling the oiler tube with 10 drops of SAE 30 wt. non-detergent
motor oil every 3 months. The oiler tube is located under the top cover directly above
the exercise arm.
To Next Page
