3.3.1 Fixed Parameters
The top portion of the MIDI Parameters tab contains options related to the behavior of the 12 Step
and some more general MIDI parameters (program changes, MIDI channel, bend range, etc.) that
remain fixed per preset.
(1) Voice A and Voice B
The 12 Step is capable of outputting MIDI on two separate “voices” simultaneously — each with
independent settings. This is useful when doubling up synths and controlling them from a
single controller.
There are two columns for each of the MIDI-related options —!one for Voice A and one for Voice
B. Each voice can be sending on a separate MIDI channel, have different transpositions,
different bend ranges, and send different program change and bank select messages.
(2) MIDI Channel
Sets the MIDI channel to output MIDI messages on.
(3) Program Change
Sets a Program Change value to output whenever the preset is loaded.
This is useful for loading specific presets/settings whenever a certain 12 Step preset is
selected.
•
Range: 0-127
(4) Bank
Sets a Bank Select message to output whenever the preset is loaded. The bank message will
only be sent out if program change is turned on as well.
•
Range: 0-127
MIDI Channel
Voice A
Voice B
Program Change
Bank
Bend Range
Transpose
1
17
off off
12
0
1
off
2
0
Note Mode
NORMAL
LEGATO
TOGGLE
HOLD
SINGLE KEY
MULTI KEY
Key Safety
1
2
3
4
5
6
7 8
12 Step Editor 31
To Next Page
Loading...
Need help?
General