In this section:
Status reporting ........................................................................ 5-1
Status reporting
The Model 2290-5 reports on its status with two registers: the Status Byte Register and the Standard
Event Status Register. The overall configuration of these registers is shown in the next figure. Note
that bits 0, 1, and 8 through 15 of both the Standard Event Status Register and Standard Event
Status Enable Register are not used in the Model 2290-5 and are always set to zero.
On power-up, the 2290-5 will either clear all of its status enable registers or maintain them in the state
they were in during power-down. The action taken is controlled by the *PSC command and allows
events such as SRQ on power-up to be generated if desired.
Figure 11: Model 2290-5 Status model
Section 5
Status messages
To Next Page
Loading...
