Keithley DMM6500 Quick Start Guide

Unpack
Check fuse settings
The fuse is set at the factory. Check the power module on the
back of the instrument. The correct voltage setting should be
displayed.
To change the fuse orientation:
1. Make sure the POWER is o󰀨.
2. Remove all test leads connected to the instrument.
3. Remove the power cord.
4. Squeeze the tabs on the fuse case and remove the fuse
case from the power module.
5. Remove the fuse from the fuse case.
6. Rotate the fuse so the proper voltage on the fuse shows
in the fuse case when installed.
7. Install the fuse case in the power module.

Keithley DMM6500 Specifications

General

Brand	Keithley
Model	DMM6500
Category	Multimeter
Language	English