Series 2600 System SourceMeters Reference Manual Instrument Control Library 12-31
Return to Section 12 topics 2600S-901-01 Rev. A / May 2006
Details See “Load test menu” on Section 14.
Also see display.loadmenu.delete
Examples Example 1 – Assume a script with a function named “DUT1” has already been loaded
into the Series 2600, and the script has NOT been saved in non-volatile memory.
Now assume you want to add a test named “Test” to the USER TESTS menu. You
want the test to run the function named “DUT1” and sound the beeper. The following
command will add “Test” to the menu, define the chunk, and then save
displayname
and
chunk in non-volatile memory:
display.loadmenu.add("Test", "DUT1() beeper.beep(2, 500)",
display.SAVE)
When “Test” is run from the front panel USER TESTS menu, the function named
“DUT1” will execute and the beeper will beep for two seconds.
Now assume you cycle power on the Series 2600. Since the script was not saved in
non-volatile memory, the function named “DUT1” is lost. When “Test” is again run from
the front panel, the beeper will beep, but “DUT1” will not execute because it no longer
exists in the chunk.
Example 2 – Adds entry called “Part1” to the front panel “USER TESTS” load menu for
the chunk “testpart([[Part1]], 5.0)”, and saves it in non-volatile memory:
display.loadmenu.add("Part1", "testpart([[Part1]], 5.0)",
display.SAVE)
display.loadmenu.delete
Function Deletes an entry from the “USER” submenu of the “LOAD TEST” menu.
Usage
display.loadmenu.delete(displayname)
displayname Name to remove from the menu.
Remarks
This function is used to delete an entry (displayname) from the front panel USER
TESTS submenu of the LOAD TEST menu.
Details See “Load test menu” on Section 14.
Also see display.loadmenu.add
Example Removes the entry named “Part1” from the front panel “USER TESTS” load menu:
display.loadmenu.delete("Part1")
To Next Page
Loading...
Need help?
General
