Series 2600 System SourceMeters Reference Manual Instrument Control Library 12-41
Return to Section 12 topics 2600S-901-01 Rev. A / May 2006
errorqueue functions and attribute
The functions and attribute in this group are used to read the entries in the error/event
queue.
errorqueue.clear
Function Clears all entries out of the error/event queue.
Usage
errorqueue.clear()
Remarks This function removes all entries from the error/event queue.
Details See Appendix B (error and status messages) and Appendix D (status model).
Also see errorqueue.count, errorqueue.next
errorqueue.count
Attribute The number of entries in the error/event queue.
Usage
count = errorqueue.count
Remarks This attribute can be read to determine the number of messages in the error/event
queue. This is a read-only attribute. Writing to this attribute will generate an error.
Details See Appendix B (error and status messages) and Appendix D (status model).
Also see errorqueue.clear, errorqueue.next
Example
Reads number of entries in the error/event queue:
count = errorqueue.count
print(count)
Output: 4.000000e+00
The above output indicates that there are four entries in the event/error queue.
To Next Page
Loading...
Need help?
General
