D-8 Status Model Series 2600 System SourceMeters Reference Manual
2600S-901-01 Rev. A / May 2006 Return to Appendix D topics
Status function summary
The following functions control and read the various registers. (Table D-1).
Common status commands are listed in Appendix C. Additional information is
included later in the section in command listings for the various register sets.
Table D-1
Status functions and registers
Type Function
1
System summary status.reset
status.node_enable
status.request_enable
status.node_event
status.request_event
status.condition
Measurement event status.measurement.*
status.measurement.instrument.smuX.*
status.measurement.instrument.*
status.measurement.voltage_limit.*
status.measurement.current_limit.*
status.measurement.buffer_available.*
status.measurement.reading_overflow.*
Operation event status.operation.*
status.operation.instrument.smuX.*
status.operation.instrument.*
status.operation.calibrating.*
status.operation.measuring.*
status.operation.user.*
Questionable event status.questionable.*
status.questionable.instrument.smuX.*
status.questionable.instrument.*
status.questionable.calibration.*
status.questionable.over_temperature.*
Standard event status.standard.enable
1. * = '.ntr', '.ptr' and '.enable'; smuX = smua or smub.
To Next Page
Loading...
Need help?
General
