EN
3. USING THE MACHINE
3.1 Control panel functions
ON/OFF switch
This switch turns the machine on and o.
Gas test button
Press to test the shielding gas ow.
Gas selection button
Press to select either CO₂ or mixed shielding gas (MAG).
Press to select between 2T and 4T gun trigger modes.
Crater Fill selection button
Press to select the Crater Fill mode ON or OFF.
Wire feed speed adjustment knob
Turn to set the wire feed speed value for the Crater Fill mode.
Voltage adjustment knob
Turn to set the welding voltage value for the Crater Fill mode.
9
© Kemppi Oy / 1308
To Next Page
Loading...
Need help?
General
