EN
3.8 Calibrating wire feed speed
To ensure that the pre-sets and meter displays work as planned, you must calibrate the wire
feed speed of your Hiarc power source and F 10 wire feeder welding equipment.
Calibration
1. Start the calibration by pressing Crater Fill button for 3 seconds.
2. Press Gas Test button to select either HiArc F 10 or HiArc F 30 wire feeder.
3. Cut the ller wire at the contact tip.
4. Press Wire Inch button at the wire feeder.
• Wire feed starts and continues for 12 seconds
5. When wire feed stops, cut the wire at the contact tip and measure the length of the fed
wire in mm.
13
© Kemppi Oy / 1308
To Next Page
Loading...
Need help?
General
