Kemppi KEMPACT - Preface; Introduction to KEMPACT Pulse 2800 MVU; KEMPACT Pulse 2800 MVU Automotive Product Details; Safe Operation Guidelines

Kempact™ pulse 2800 mVu automotiVe / 0709 – 3© Kemppi oy
1. PREFACE
1.1. INTRODUCTION
Congratulations on having purchased a KEMPPI product. Properly installed and used KEMPPI
products should prove to be productive machines requiring only a small amount of regular
maintenance.This manual is designed to give you a good understanding of the equipment and its safe
use. There is also information on maintenance of the unit and the machine´s technical data. Read
the instructions before bringing the machine into use or servicing it for the rst time. Additional
information on Kemppi products and their use can be obtained from Kemppi or a Kemppi dealer.
The specications and designs presented in this manual are subject to change without prior notice.
In this document, the following symbol is used to indicate a risk of injury or death:
Read the warnings carefully and follow the instructions. Please also study the instructions for safe
operation and follow them when installing, operating and servicing the machine.
1.2. PRODUCT INTRODUCTION
Kempact™ Pulse 2800 MVU Automotive is a compact puls MIG inverter specially suitable for
car body repair. Good MIG brazing characteristics have been emphasized in designing of the
machine.
1.3. SAFE OPERATION
Read the warnings carefully and follow the instructions.
Welding arc and spatter
The arc and the reected radiation from it can damage unprotected eyes. Shield your eyes and
protect your surroundings appropriately before you start welding. The arc and welding spatter will
burn unprotected skin. When welding, use protective clothes and clothing.
Danger of re and explosion
Observe the re safety instructions. Remove ammable material in and near the location in which
you will weld. Make sure the necessary re extinguisher equipment is nearby. Note the dangers
posed by special jobs, such as the risk of re and explosion when welding tanks. Note! Sparks
may ignite a re even hours later! Welding involves working with a naked ame, note the special
instructions for such work.
Mains voltage
Never bring the welding machine inside the work piece (e.g. container or car). Never set the
welding machine on a wet surface. Replace faulty cables immediately, they create a danger to life
and can cause a re. Ensure that the connecting cable does not stick, touch sharp edges, or come
in contact with a hot piece.
Welding current circuit
Isolate yourself from the welding current circuit by wearing dry and undamaged protective clothing.
Never work on a wet surface. Never use damaged welding cables. Never set the electrode holder,
earth clamp, or welding cables on top of the power source or other electrical equipment.
Welding fumes
Ensure adequate ventilation. Always take special measures when welding metals containing lead,
cadmium, zinc, mercury or beryllium.
This equipment’s electromagnetic compatibility (EMC) makes it suitable for use in an
industrial environment. Class A equipment is not intended for use in a residential location
where the electrical power is provided by the public low-voltage supply system.