Kemppi Master M 323 User Manual

Master M 205, 323
Operating manual - EN
3.5 Changing welding polarity
Welding polarity needs to changed for TIG welding. Also, some filler wires require changing the welding polarity. Check
the recommended welding polarity on the filler wire package.
Before handling electrical parts, ensure the welding device is disconnected from the mains.
Tools needed:
17 mm
Turn off the welding device and disconnect it from the mains.
1. Open the wire feed cabinet hatch.
2. Remove the protective rubber covers from the polarity terminals.
Use caution when handling electrical parts.
© Kemppi
49
1922130 / 2313

Kemppi Master M 323 Specifications

General

Brand	Kemppi
Model	Master M 323
Category	Welding System
Language	English