Need help?Do you have a question about the Kemppi MasterTig 335ACDC and is the answer not in the manual?
Overview of Kemppi MasterTig welding equipment, including power sources, control panels, and cooling units.
Instructions for connecting the mains power plug to the welding equipment.
Step-by-step guide for mounting and securing the control panel.
Procedures for installing the MasterTig Cooler M unit with the power source.
Steps for connecting both gas-cooled and water-cooled TIG torches.
How to properly connect the earth return cable and clamp to the workpiece.
Procedures for safely installing and connecting a gas bottle.
How to turn on and start the welding power source.
List of error codes, their possible reasons, and proposed actions for resolution.
General| Open circuit voltage | 70-80 V |
|---|---|
| Weight | 24 kg |
| Protection class | IP23S |
| Input Voltage | 3 x 400 V |
| Connection voltage 50/60 Hz | 3 x 400 V |
| AC Frequency | 20 - 200 Hz |
| Dimensions (L x W x H) | 500 x 180 x 390 mm |
| Standards | IEC 60974-1, IEC 60974-10 |
To Next Page