MasterTig 235ACDC, 325DC, 335ACDC, 425DC
Operating manual - EN
2.1 Installing mains plug
Only an authorized electrician is allowed to install the mains cable and plug.
Do not connect the machine to the mains before the installation is complete.
Install the 3-phase plug according to the MasterTig power source and site requirements. In the 1-phase power source
(MasterTig 235ACDC) the plug is pre-installed. Refer also to "Technical data" on page61 for power source specific tech-
nical information.
© Kemppi
8
1920900 / 2052
To Next Page
Loading...
Need help?
General
