Kemppi Minarc 150 User Manual

EN
8. WARRANTY POLICY
Kemppi Oy provides a warranty for products manufactured and sold by the
company if defects in materials or workmanship occur. Warranty repairs are to
be carried out only by an authorised Kemppi Service Agent. Packing, shipping,
andinsuranceareattheorderer’sexpense.
The warranty starts on the date of purchase. Spoken promises not included in
the terms of warranty are not binding on the warrantor.
Limitations of the warranty
The following conditions are not covered under the terms of warranty:
defectsarisingfromnormalwearandtear,non-compliancewithoperation
and maintenance instructions, overloading, negligence, connection
to incorrect or faulty supply voltage (including voltage surges outside
equipment specications), incorrect gas pressure, anomalies or failures in
the electric network, transport or storage damage, and re or damage due to
forces of nature. This warranty does not cover direct or indirect travel costs,
daily allowances, or accommodation related to warranty service.
The warranty does not cover welding torches and their consumables, feeder
drive rolls,
and feeder guide tubes. Direct or indirect damage caused by a defective
product is not covered under the warranty.
The warranty becomes void if modications are made to the machine that
arenotapprovedbythemanufacturerorifnon-originalsparepartsareused
in repairs. The warranty is also voided if repairs are carried out by a repair
agent not authorised by Kemppi.
Undertaking warranty repairs
Warranty defects must be reported to Kemppi or an authorised Kemppi
Service Agent without delay.
Before a warranty repair is undertaken, the customer must present proof
of warranty or otherwise prove the validity of the warranty in writing. The
proof must indicate the date of purchase and the manufacturing number of
the unit to be repaired. The parts replaced under the terms of this warranty
remain the property of Kemppi and must be returned to Kemppi if requested.
After a warranty repair, the warranty of the machine or equipment, repaired
or replaced, shall be continued to the end of the original warranty period.
18
Minarc 150, 151, 150 VRD, 120/150 AU / © Kemppi Oy / 0901

Kemppi Minarc 150 Specifications

General

Input Voltage	230 V
Protection Class	IP23S
Input Current	16 A
Welding Current Range	10 - 150 A
Weight	4.0 kg
Output Current	150 A
Electrode Size	1.5 - 3.25 mm
Power Supply	Single-phase
Welding Processes	MMA