Kemppi Minarc 150 User Manual

EN
1. PREFACE
1.1 INTRODUCTION
Congratulations on having purchased a KEMPPI product. Properly installed
and used KEMPPI products should prove to be productive machines
requiring only a small amount of regular maintenance.
This manual is arranged to give you a good understanding of the equipment
and its safe use. There is also information on both servicing the unit as well as
its technical data. Read the instructions before taking the machine into use or
servicing it for the rst time. Additional information on Kemppi products and
their use can be obtained from Kemppi or a Kemppi dealer.
The specications and designs presented in this manual are subject to
change without prior notice.
NOTE! Items in the manual that require particular attention in order to minimise
damage and personal harm are indicated with this symbol. Read these sections
carefully and follow their instructions.
1.2 SAFETY INSTRUCTIONS
Kemppi welding devices conform to international safety standards. Safety
is an important issue in equipment design and manufacturing. Therefore,
Kemppi welding solutions are unparalleled in safety. There are, however,
always certain hazards involved in using welding equipment. Therefore, to
ensure your personal safety and the safety of your working environment,
carefully read the safety instructions below and respect them.
Use of personal protective equipment
• Thearcanditsreectingradiationdamageunprotectedeyes.Shield
your eyes and face appropriately before you start welding or observe
welding. Also note the dierent requirements for the darkness of the
screen in the mask as the welding current changes.
• Thearcradiationandspattersburnunprotectedskin.Alwayswear
protective gloves, clothing and footwear when welding.
• Alwayswearhearingprotectioniftheambientnoiselevelexceedsthe
allowable limit (e.g., 85 dB(A)).
General operating safety
• Exercisecautionwhenhandlingpartsheatedinwelding.Forexample,
the tip of the welding torch, the end of the welding rod and the work
piece will heat during gouging to a burning temperature.
3
Minarc 150, 151, 150 VRD, 120/150 AU / © Kemppi Oy / 0901

Kemppi Minarc 150 Specifications

General

Input Voltage	230 V
Protection Class	IP23S
Input Current	16 A
Welding Current Range	10 - 150 A
Weight	4.0 kg
Output Current	150 A
Electrode Size	1.5 - 3.25 mm
Power Supply	Single-phase
Welding Processes	MMA