Kemppi Minarc 150 User Manual

EN
• Neverwearthedeviceontheshoulderduringweldingandnever
suspend it by the carrying strap during welding.
• Donotexposethemachinetohightemperatures,asheatmaycause
damage to the machine.
• Keepthetorchcableandearthingcableasclosetoeachotheras
possible throughout their length. Straighten any loops in the cables. This
minimisesyourexposuretoharmfulmagneticelds,whichmayinterfere
withapacemaker,forexample.
• Donotwrapthecablesaroundthebody.
• Inenvironmentsclassiedasdangerous,onlyuseS-markedwelding
devices with a safe idle voltage level. These work environments include,
forexample,humid,hotorsmallspaceswheretheusermaybedirectly
exposedtothesurroundingconductivepieces.
Spatter and re safety
• Weldingisalwaysclassiedashotwork,sopayattentiontoresafety
regulations during welding and after it.
• Rememberthatrecanbreakoutfromsparksevenseveralhoursafter
the welding work is completed.
• Protecttheenvironmentfromweldingsplatter.Removeammable
materials,suchasammableuids,fromtheweldingvicinityandsupply
the welding site with adequate re ghting equipment.
• Inspecialweldingjobs,bepreparedforhazardssuchasreorexplosion
when welding container type work pieces.
• Neverdirectthesparksprayorcuttingsprayofagrindertowardthe
weldingmachineorammablematerials.
• Bewareofhotobjectsorsplatterfallingonthemachinewhenworking
above the machine.
• Weldinginammableorexplosivesitesisabsolutelyforbidden.
General electric safety
• Onlyconnecttheweldingmachinetoanearthedelectricnetwork.
• Notetherecommendedmainsfusesize.
• Donottaketheweldingmachineinsideacontainer,vehicleorsimilar
work piece.
• Donotplacetheweldingmachineonawetsurfaceanddonotworkon
a wet surface.
• Donotallowthemainscabletobedirectlyexposedtowater.
• Ensurecablesorweldingtorchesarenotsquashedbyheavyobjectsand
thattheyarenotexposedtosharpedgesorahotworkpiece.
4
Minarc 150, 151, 150 VRD, 120/150 AU / © Kemppi Oy / 0901

Kemppi Minarc 150 Specifications

General

Input Voltage	230 V
Protection Class	IP23S
Input Current	16 A
Welding Current Range	10 - 150 A
Weight	4.0 kg
Output Current	150 A
Electrode Size	1.5 - 3.25 mm
Power Supply	Single-phase
Welding Processes	MMA