EN
3. MAINTENANCE
All electromechanical devices require routine service maintenance
depending on usage. This type of routine maintenance will prevent hazards
and malfunctions.
We recommend that you schedule a service inspection of your welding
machine every six months. An authorised Kemppi service agent will inspect
and clean your machine, ensuring that all power connections are tight and
secure. Power connections can become loose and oxidised with frequent and
high changes in temperature.
NOTE! Disconnect the machine from the mains power supply before handling
electric cables.
3.1 DAILY MAINTENANCE
• Check the welding torch electrode. Sharpen the electrode or replace a
damaged one.
• Check the tightness of the earthing cable connections.
• Check the condition of mains and welding cables and replace damaged
cables.
3.2 DISPOSAL
Do not dispose of electrical equipment with normal waste!
In observance of European Directive 2002/96/EC on waste electrical
and electronic equipment, and its implementation in accordance with
national law, electrical equipment that has reached the end of its life must
be collected separately and taken to an appropriate environmentally
responsible recycling facility.
The owner of the equipment is obliged to deliver a decommissioned unit
to a regional collection centre, per the instructions of local authorities
or a Kemppi representative. By applying this European Directive you will
improve the environment and human health.
10
Minarc 220 / © Kemppi Oy / 1117
To Next Page
Loading...
Need help?
General
