EN
1. PREFACE
1.1 GENERAL
Congratulations on choosing the Minarc 220 equipment. Used correctly,
Kemppi products can signicantly increase the productivity of your welding,
and provide years of economical service.
This operating manual contains important information on the use,
maintenance and safety of your Kemppi product. The technical specications
of the equipment can be found at the end of the manual.
Please read the manual carefully before using the equipment for the rst
time. For your own safety and that of your working environment, pay
particular attention to the safety instructions in the manual.
For more information on Kemppi products, contact Kemppi Oy, consult an
authorised Kemppi dealer, or visit the Kemppi web site at www.kemppi.com.
The specications presented in this manual are subject to change without
prior notice.
Important notes
Items in the manual that require particular attention in order to minimise
damage and personal harm are indicated with the ’NOTE!’ notation. Read
these sections carefully and follow their instructions.
1.2 MACHINE PROPERTIES
The Minarc 220 is intended for use in a three-phase electric network. It is
designed to be a compact and ecient direct current MMA/TIG machine.
Extremely light in weight for its high 220 A output power, the machine is easy
to carry to the work place with either the inbuilt moulded carry handle or the
shoulder strap provided.
1.3 ABOUT WELDING
Minarc 220 provides high quality welding results time after time provided
the correct operational procedures are followed. Welding quality is not only
inuenced by the machine itself. Personal expertise, ancilliary equipment and
consumables also play an essential role, as does the correct, fused supply power.
Welding is carried out when an electric arc is established between the
welding electrode and work piece. Welding is not possible unless the
equipment is correctly set-up, including the earthing cable attached to the
work piece. This cable creates the welding circuit that allows the welding
current to ow. Please check the earthing clamp is on the work piece to be
welded, and that the area of the clamps contact is clean and free from paint.
3
Minarc 220 / © Kemppi Oy / 1117
To Next Page
Loading...
Need help?
General
