MinarcMig™ Adaptive 180
© Kemppi Oy 0640 13
3.5. CONTROLS AND INDICATOR LIGHTS
Figure 3.6. Machine's front panel in automatic mode
1. Welding power control (automatic mode) OR Wire feed speed control
(manual mode)
2. Arc length trimmer (automatic mode) OR Welding voltage control
(manual mode)
3. Standby indicator light
4. Overheating indicator light
5. Mode selection button
6. Material selection button (automatic mode)
7. Display
In automatic mode, the welding power is adjusted according to the thickness of
the welded sheet. The machine also has a trimmer for arc length in automatic
mode . There are three material options for ller wires and you can browse
through them with the material selection button.
In manual mode, the wire feed speed and welding voltage are adjusted
separately. Modes can be changed with the mode selection button. Note that
material or sheet thickness selections made in the automatic mode are not valid
in manual mode or manual mode’s selections in automatic mode.
Indicator lights display the machine’s standby mode and inform of a possible
overheating.
EN
To Next Page
Loading...
Need help?
General
