EN
2.7 FILLER WIRE
The machine is delivered with the welding gun connected to the positive pole (+) making it
suitable for welding with solid steel, stainless steel, aluminium and CuSi ller wires without
extra adjustments.
2.7.1 Changing the feed roll groove
When the machine leaves factory, the feed roll groove is set for welding with ller wires of
0.8–1.0 mm diameter. The feed roll groove must be changed, if you use 0.6 mm thick ller wire.
Changing the feed roll groove
1., 9.
7.
2., 4.
3.
5., 8.
6.
1. Release the pressure control lever.
2. Switch the machine on from the main switch.
3. Press the welding gun trigger and drive the feed roll in such a position that the locking
screw is clearly visible and can be accessed.
4. Switch the power o from the main switch.
5. Release the feed roll locking screw with a 3.0 mm Allen wrench approximately half a
turn.
6. Pull the feed roll from its shaft.
7. Turn the feed roll around and reinstall it to the shaft all the way to the bottom stop,
making sure that the screw is parallel to the at area ground onto the shaft.
8. Tighten the feed roll locking screw.
9. Close the pressure control lever.
8
MinarcMig Evo 200 / © Kemppi Oy / 1110
To Next Page
Loading...
Need help?
General
