Kenmore 1350 - Picking up Bobbin Thread

PICKING UP BOBBIN THREAD
1. Raise presser foot lever. Hold needle
thread loosely in left hand and rotate
handwheel toward you one complete
turn.
2. Bring boonin thread up by pulling upper
thread.
3. Pull both threads under and to the back
of the presser foot, leaving 3 to 4 inches
of thread clear.
If you can not pick up bottom thread by
following above steps, then check,
1. Is your threading through needle?
2. Isn't thread tangled around needle?
3. Is there 3 to 4 inches of lead thread
coming out from bobbin case?
4. Isn't lead thread from bobbin case
tangled?
9