Kenmore 1350 - Darning Plate; Presser Feet

There are a few times when you want to
control the feeding of the fabric yourself.
Raise needle to its highest position and raise
presser foot. Place darning plate over needle
plate aligning two pins of darning plate with
holes of needle plate. You may then
determine the movement of the fabric
yourself. See page 19 and 22 for sewing
application.
To change the various presser feet, raise the
presser bar to its highest position by lifting
the presser foot lever (See page 13). Loosen
the presser foot thumb screw, choose the
proper foot, insert from the front. Lower the
presser foot lever and tighten the screw using
the large screw driver to make certain the
foot is secure.
You have a variety of presser feet:
A. Zigzag Foot
B. Straight Stitch Foot
C. Satin Stitch Foot
D. Buttonhole Guide Foot
Applications are provided in appropriate
sewing section.
16