Kenmore 15358 - Threading the Machine; Threading the Ma

Threading the Machine
• Threading the machine
• Raise the thread take-up lever to its highest position by
turning the handwheel counterclockwise.
• Raise the presser foot lifter.
• Place a spool on the spool pin, with thread coming off
as shown.
[]
,E
] ...........
C []
/
I
J
- \
[] Draw the end of thread around the upper thread guide.
] %,
[_]While holding the thread near the spool, draw the end of
the thread down around the check spring h(
[] Firmly draw the
take-up lever the
to left over the
lever eye.
[] Slide the thread behind the needle bar thread guide on
the left.
[] Thread the needle from front to back.
[]
24