Twin Needle Stitches (Option)
_1_Stitch selector: 2 to 2.5
_2_Presser foot: Zigzag foot
_3_Needle thread tension: 1 to 4
_4_Needle: Twin needle (optional item)
NOTE: Do not set the stitch pattern selector at any
position higher than the middle of 2 and 3, otherwise the
needle may hit the needle plate or presser foot and could
possibly break.
:,_i_Upper thread guide
_.2_'Check spring holder
,'3_:Thread take-up lever
(47Needle bar thread guide
_5_Twin needle (optional item)
Turn off the power switch. Pull up the additional spool pin.
Place a piece of felt on the additional spool pin. Make sure
you separate the two strands of thread and slip one strand
through the needle bar thread guide _4:_onthe left and the
other on the right.
Change the needle to a twin needle _5_.Thread each needle
from front to back.
When you want to shift the fabric to
direction, you must first raise the needle
S
(_.!J)
2 3
I
<I_
S"X
\
....!i!i!!i!!i:
%i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i_:i_
,I
62
To Next Page