o Inserting bobbin
[_ Place a bobbin in the bobbin case, making sure the
thread feeds clockwise from the bobbin
[] Draw the thread through the slot of the case.
[_ Continue to draw the thread under the tension spring (_
and through the opening,
Pull out about 4" (t 0 cm) of thread
(_ Tension spring
[] Holding the latch open, position the bobbin case into the
shuttle, and then release the latch,
[_The case should lock into the place when the latch is
release&
53
[]
%
L J
D
[]
J
24
To Next Page
Loading...
