Leveling the Range
Models Equipped with Leveling Device
Level the range after installation in the cutout
opening.
1. Open the range drawer. The leveling screws control
the height of the rear leg.
2. Adjust the appliance legs as follows until the
underside of the cooktop (or cooktop glass) surface
is sitting level on the countertop (Figure 7).
a.To adjust the front legs_ use a wrench on the
leg base and turn counterclockwise to lower or
clockwise to raise the range.
b.To adjust the rear legs_ use a ratchet or
a nutdriver and turn the leveling screws
counterclockwise to lower or clockwise to raise
the range.
3. Check if the range is level by installing an oven rack
in the center of the oven and placing a level on the
rack (Figure 8).
4. Take 2 readings with the level placed diagonally in
one direction and then the other. Level the range° if
necessary_ by adjusting the leveling legs.
5. If the range cannot be level I contact a carpenter to
correct sagging or sloping floor.
Levellnl
Front
Leveffng
Leg
LOWER
RAISE
Figure 7
Models Equipped with Levelin_
Level the range and set cooktop height before
installation in the cut-out opening.
1. Install an oven rack in the center of the oven.
2. Place a level on the rack (see Figure 8). Take 2
readings with the level placed diagonally in one
direction and then the other. Level the range_ if
necessary_ by adjusting the 4 leg levelers with a
wrench (see Figure 18).
3. Taking care to not damage the countertop, slide
range into cutout opening and double check for
levelness. ........ ....
............. F*
@
i
J
i
1. Disconnect the power from the range.
2. Make sure the range is leveled.
3. Pull range toward you.
4. Measure the distance between the floor and the
surface underneath the cooktop frame.
5. Marl< that distance on the wall where the decorative
trim will be installed.
6. Draw a line.
Z Place the top of the decorative trim under that line.
8. Using the screws provided fix the decorative trim
into the wail.
9. Slide the range back into position as far as it will
go and reconnect the power source.
Tri m
Figure 9
9
To Next Page
Loading...
