Kentec Electronics Sigma A-CP - Panel Controls and Indicators

Panel Controls and Indicators
The fascia of the Sigma A-CP Fire Control Panel is divided into sections for controls and indicators.
The figure below illustrates controls and indicators of the Sigma A-CP Fire Control Panel:
Figure 2-3
Controls and Indicators
Key Description Key Description
A
Upper Indicators
D
Upper Controls
B
Central Controls
E
Lower Controls
C
Lower Indicators
General System Status
Disabled
NAC Trouble
Mode
(+1)
Trbl.
(+10)
Trbl.
Trouble/Test/Disablement
Trouble/Test/Disablement
Enter
Trbl.
Select
Trbl.
Mode
Trbl.
Reset
Trbl.
Enable Access
Test Mode On
Delay On
AC Power On
Alarm Silenced
Supervisory
Disablement
System Trouble
General Trouble
Lamp Test
Trbl.
Silence/Resound
Fire Drill
Trbl.
Silence Buzzer
Trbl.
8765
4321
Fire
Alarm In Zone
Alarm In Zone
Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.
NAC1 NAC2Sys.FuseEarth
Trbl.Trbl.Trbl.Trbl.Trbl.
Comms
Low
Batt.
Trbl.
Aux.24V
Trbl.
CPU
Fail
Batt.
Fail
Mains
W/Dog
Reset
Processor
Reset
Write
Enable
Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.Trbl.
A
B
C
A
B
C
D
E
www.acornfiresecurity.com
www.acornfiresecurity.com