Date: 8/31/2012
Performing Commands
Commands are visible on the touch-panel-display when the Taktis Fire Control Panel is reporting fire alarms.
Commands are not visible when the fire control panel is not reporting fire alarms or fault conditions. The Fire
System Normal condition is displayed when the Taktis Fire Control Panel is not reporting fire alarms or fault
conditions.
User Access Levels
User access levels are displayed in the lower-right corner of the touch-panel-display when the fire control
panel is reporting fire alarms. The access levels can include the No User Level and User Level 2.
No User Level
Commands of the No User Level are visible on the touch-panel-display. Menu access to the No User Level is
available when operating the Taktis Fire Control Panel following a power-up condition. Commands of the
No User Level are limited to the Lamp and Buzzer Test, Display Test and Buzzer Silence.
User Level 2
Commands under User Level 2 are visible on the touch-panel-display. Menu access to User Level 2 is
available when the password 222222 is submitted on the Logon window of the Taktis Fire Control Panel.
An optional Access Control Keyswitch can be fitted to the fascia of the fire control panel to provide access to
User Level 2.
Visible commands under User Level 2 a
uthorization include:
! Silence Alarms
! Re-sound Alarm
! Reset System
A delay control button is visible on the touch-panel-display when the Taktis Fire Control Panel is configured with
output delays and these delays are enabled.
To Next Page
Loading...
