EasyManua.ls Logo

Kenwood KDC-BT21 - CALL HANDLING OPERATIONS; ADJUSTING CALL VOLUME; ENHANCING VOICE QUALITY; CALL RECEIVING SETTINGS

Kenwood KDC-BT21
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGLISH
17
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
BLUETOOTH®
To On the faceplate On the remote control
While talking on the first incoming call...
Answer another incoming
call and hold the current
call
Press
. Press .
Reject another incoming
call
Press
.
Press
.
While having two active calls...
End current call and
activate held call
Press
.
Press
.
Swap between the
current call and held call
Press
. Press .
Adjust the phone volume
[00]
to
[35]
(Default:
[15]
)
Turn the volume knob during
a call.
This adjustment will not
affect the volume of the other
sources.
( Not available )
Switch between hands-free
and private talk modes
Press
during a call.
Operations may vary
according to the connected
Bluetooth device.
( Not available )
Improve the voice quality
While talking on the phone...
1 Press the volume knob to enter
[FUNCTION]
.
2 Turn the volume knob to select an item (see the following table), then press the
knob.
3 Repeat step 2 until the desired item is selected or activated.
4 Press and hold to exit.
To return to the previous setting item, press .
Default:
XX
MIC GAIN –10
to
+10
(
–4
):The sensitivity of the microphone
increases as the number increased.
NR LEVEL –5
to
+5
(
0
):Adjust the noise reduction level
until the least noise is being heard during a phone
conversation.
ECHO CANCEL –5
to
+5
(
0
):Adjust the echo cancellation delay
time until the least echo is being heard during a
phone conversation.
Make the settings for receiving a call
1
Press to enter Bluetooth mode.
2 Turn the volume knob to select an item (see the
following table), then press the knob.
3 Repeat step 2 until the desired item is selected or
activated.
4 Press and hold to exit.
To return to the previous setting item, press .
Default:
XX
SETTINGS
AUTO ANSWER
1
to
30
:The unit answers incoming call automatically
in the selected time (in seconds).;
OFF
:Cancels.
BATT/SIGNAL*
(For / )
AUTO
:Shows the strength of the battery and signal
when the unit detects a Bluetooth device and the
Bluetooth device is connected.;
OFF
:Cancels. Clock
time is shown.
*
Functionality depends on the type of the phone used.
JS_KWD_KDC_X301_KN_EN_4.indd 17JS_KWD_KDC_X301_KN_EN_4.indd 17 21/7/2016 11:40:41 AM21/7/2016 11:40:41 AM

Related product manuals