ENGLISH
15
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
Pair and connect a Bluetooth device for the first time
1
Press B SRC to turn on the unit.
2 Search and select the name of your receiver (“KDC-BT660U”/
“KDC-BT560U”) on the Bluetooth device.
“PAIRING” “PASS XXXXXX” “Device name” “PRESS” “VOLUME
KNOB” appears on the display.
• For some Bluetooth devices, you may need to enter the Personal
Identification Number (PIN) code immediately after searching.
3 Press the volume knob to start pairing.
“PAIRING OK” appears when pairing is completed.
Once pairing is completed, Bluetooth connection is established
automatically.
•
: “BT1 CONNECTED” and/or “BT2 CONNECTED” appears on
the display window for 2 seconds.
“
” indicator lights up to show the strength of the battery and signal of
the connected device.
•
: “BT1” and/or “BT2” indicator on the display window lights
up.
• This unit supports Secure Simple Pairing (SSP).
• Up to five devices can be registered (paired) in total.
• Once the pairing is completed, the Bluetooth device will remain registered
in the unit even if you reset the unit. To delete the paired device, see
[DEVICE DELETE]
on page19.
• A maximum of two Bluetooth phones and one Bluetooth audio device can
be connected at any time. To connect or disconnect the registered device,
see
[PHONE SELECT]
or
[AUDIO SELECT]
in
[BT MODE]
. (Page 19)
However, while in BT AUDIO source, you can connect to five Bluetooth
audio devices and switch between these five devices. (Page20)
• Some Bluetooth devices may not automatically connect to the unit after
pairing. Connect the device to the unit manually.
• Refer to the instruction manual of the Bluetooth device for more
information.
Bluetooth®
(for / )
Auto Pairing
(for )
When you connect iPhone/iPod touch to the USB input terminal, pairing
request (via Bluetooth) is automatically activated if
[AUTO PAIRING]
is set to
[ON]
. (Page 19)
Press the volume knob to pair once you have confirmed the device name.
Bluetooth — Mobile phone
Receive a call
When there is an incoming call:
•
:
[ZONE 2]
illuminates in green color and flashes.
• The unit answers the call automatically if
[AUTO ANSWER]
is set to a selected
time. (Page17)
During a call:
•
:
[ZONE 1]
illuminates according to the settings made for
[DISPLAY]
(page26) and
[ZONE 2]
illuminates in green color.
• If you turn off the unit or detach the faceplate, Bluetooth is disconnected.
JS_KWD_KDC_BT660U_MN_EN.indd 15JS_KWD_KDC_BT660U_MN_EN.indd 15 11/3/2021 11:14:34 AM11/3/2021 11:14:34 AM
To Next Page
Loading...
Need help?
General
