o
Making Group Calls (NXDN Trunking/ DMR Trunking)
You can select a channel with the Group ID you wanted to call to make a call to those
parties on a Trunking channel.
●
If the traffic channel is busy, a busy message appears and the busy tone sounds. Release
the PTT switch and wait for the channel to become free. When the traffic channel becomes
free, a proceed tone sounds.
1
Select the configured Group channel using the keys programmed as [Channel
Up]/ [Channel Down].
2
Press and hold the PTT switch to make the call.
●
“Calling” appears on the display while the call is being made, and disappears once
the call is established.
●
Speak into the transceiver as you would during a normal call.
o
Making Individual Calls (NXDN Trunking/ DMR Trunking)
You can make calls to specific persons on a Trunking channel.
1
Press the key programmed as [Individual], [Individual + Short Message] or
[Individual + Status] to enter Individual Call Mode.
Alternatively, press the key programmed as [Menu] to enter Individual Call Mode using
the Menu Mode.
●
The ID list appears on the display.
11
To Next Page
Loading...
Need help?
General
