BASIC OPERATIONS
SWITCHING POWER ON/ OFF
Turn the Power switch/ Volume control clockwise to switch the transceiver power
ON.
●
The following screen appears if the Custom Start-up Screen has not been set.
Turn the Power switch/ Volume control counterclockwise to switch the transceiver
power OFF.
o
Transceiver Password
If the transceiver is password protected, “Input Password” will appear on the display
when the power is turned on. To unlock the transceiver, enter the correct password.
1
Press the key programmed as [Transceiver Password] to enter Transceiver
Password Mode.
Alternatively, press the key programmed as [Menu] to enter Transceiver Password Mode
using the Menu Mode.
●
If a password has been registered and the [Transceiver Password] function has not
been programmed to a key or configured to the menu, the transceiver enters
Transceiver Password Mode when the power is turned on.
2
Enter a number using the [J] and [K] keys.
●
On full key model transceivers, you can enter the password directly by pressing the
keypad.
3
To Next Page
Loading...
Need help?
General
