DTMF (DUAL TONE MULTI FREQUENCY) CALLS
Note:
●
DTMF calls can be made only in Analog Conventional and NXDN Conventional Operation.
MAKING A DTMF CALL
o
Manual Dialing (Full key model only)
1
Press and hold the PTT switch.
2
Enter the desired digits using the DTMF keypad.
●
The corresponding DTMF tones sound each time you press a key.
●
If you release the PTT switch, transmit mode will end even if the complete number has
not been sent.
o
Keypad Auto PTT (Full key model only)
If your dealer has activated the Keypad Auto PTT function, simply press the keys on
the keypad to make the call.
●
The DTMF code will be sent automatically when you press a key.
o
Store & Send
1
Enter the desired digits using the DTMF keypad.
●
The digits appear on the display as you enter them.
●
You can enter digits by using the [J] and [K] keys. Press these keys to cycle through
the DTMF digits.
●
You can enter up to 34 digits before transmitting.
2
After entering the complete number, press the PTT switch to transmit.
o
Stun Code
This function is used when a transceiver is stolen or lost.
When the transceiver receives a call containing a stun code, either the transmit mode
or both the receive and transmit mode will be disabled. The stun code is canceled
when the transceiver receives a call with a revive code.
41
To Next Page
Loading...
Need help?
General
