EMERGENCY CALLS
If your transceiver has been programmed with the Emergency function, you can make
emergency calls.
Note:
●
Only the Auxiliary (orange) key and the PF 1 (orange) key of the optional speaker/
microphone can be programmed with the Emergency function.
1
Press and hold the key programmed as [Emergency].
●
Depending on the delay time programmed into your transceiver, the length of time you
must hold the Emergency key will vary.
●
When the transceiver enters Emergency mode, the transceiver will change to the
Emergency channel and begin transmitting based on how the transceiver is set up by
your dealer. Transmit periods are also set by your dealer.
2
To exit Emergency mode, press and hold the [Emergency] key again.
●
If the Emergency mode completes a preset number of cycles, Emergency mode will
automatically end and the transceiver will return to the zone and channel that was in
use before Emergency mode was entered.
Note:
●
Your dealer can set the transceiver to emit a tone when Emergency mode starts and stops.
●
Your dealer can set the transceiver to emit tones and received signals as normal or mute
the speaker during Emergency operation.
44
To Next Page
Loading...
Need help?
General
