Kenwood TS-2000 Service Manual (English)

Other manuals for Kenwood TS-2000

Service Manual171 pages

Instruction Manual152 pages

Operation Procedure3 pages

Specifications10 pages

Questions and Answers:

L
Lindsey DicksonAug 28, 2025
Why Kenwood TS-2000 does not respond correctly after pressing button?
- A
  Aaron NicholsAug 28, 2025
  The issue could be due to several reasons. First, ensure procedures are followed precisely. Second, check if the Frequency Lock function is ON and, if so, press [F.LOCK] to switch it OFF. Third, the microprocessor and its memory may need resetting; consider a Partial Reset or a Full Reset. Lastly, the buttons on the transceiver are unavailable while operating the Tuning control, so stop operating the Tuning control, then press the appropriate buttons.
A
Andrea MolinaAug 27, 2025
What to do if Kenwood TS-2000 Transceiver has low transmit power?
- C
  Christopher HendersonAug 27, 2025
  If your transceiver has low transmit power, first, if you are in SSB or AM mode, increase the microphone gain. Second, check antenna connections to confirm that the antenna tuner is reporting a low SWR, as poor antenna system connections can cause high SWR.
M
Mike JonesAug 26, 2025
What to do if Kenwood Transceiver received signals are totally unintelligible?
- D
  David ParkerAug 26, 2025
  If received signals are unintelligible, the wrong modulation mode may be selected. Press [LSB/USB], [CW/FSK], or [FM/AM] to select the correct modulation mode.
R
ramirezjamesAug 25, 2025
What to do if Kenwood TS-2000 will not power up?
- K
  Kelsey BrownAug 26, 2025
  First, ensure the DC power supply is switched ON. Inspect the power cable, confirming correct polarities (Red: positive (+); Black: negative (–)). Check that the connections to the DC power supply are secure. Finally, check the power cable fuse. If it's open, find the cause, correct any issues, and install a new fuse of the specified rating.
C
Charles KhanAug 25, 2025
How to unlock frequency on Kenwood Car Receiver?
- T
  thigginsAug 25, 2025
  If the frequency cannot be changed on your Kenwood Car Receiver, the Frequency Lock function or Lock All function may be ON. To resolve this, press [FUNC],[F LOCK] to switch the Frequency Lock function OFF. Alternatively, press [FUNC],[LOCK A] to switch the Lock All function OFF.

Kenwood TS-2000 Specifications

General

Antenna Impedance	50 ohms
Supply Voltage	13.8V DC ±15%
Current Drain TX	20.5A
Receiver Type	Triple Conversion Superheterodyne
Modes	SSB, CW, AM, FM, FSK
Type	Base Station
Frequency Range TX	0.1-60 MHz (HF), 144-148 MHz (VHF), 430-450 MHz (UHF)
Image Rejection	More than 70 dB
Selectivity	2.4 kHz (SSB), 500 Hz (CW), 15 kHz (FM)
Antenna Connector	SO-239
Frequency Range	HF/6m/2m/70cm