ABS/ABJ-BA-e-1019
18
4.3 Menu call
Perform the modification test once. Change the “Auto-Zero“
function to OFF and then to ON.
- Turn the balance on by using the ON/OFF/ESC key.
- Press the CAL/MENU key until FUnC.SEL appears.
- Press the TARE/ - key only once until CAL appears.
- Press the CAL/MENU key once until trC :on appears.
- Press the TARE/ - key once.
The “Auto-Zero“ function is selected.
The standby indicatorindicates the setting of the
current display.
- Press the CAL/MENU key.
This means:
trC :oF Auto-Zero is off.
trC :on Auto-Zero is on
Select trC :oF
- Press the TARE/ key once.
A colon appears when the change is stored.
- Press the ON/OFF/ESC key.
To exit the menu, press the ON/OFF/ESC key at least
2 sec.
Note:
If you wish to store several settings simultaneously on the
operating menu, you do not need to exit the menu each
time. Several settings can be set up before exiting the
menu.
To Next Page
Loading...
Need help?
General
