ABS/ABJ-BA-e-1019
45
7.5 Entering commands
If the balance is connected to a personal computer or printer, the following commands
are available.
See Chapter 7.4, "Formatting input and output data"
If errors not appearing here are transmitted to the balance, proper balance operation is
not guaranteed. In this case, unplug the balance from the power outlet for 10 seconds.
Command code Function Content
D01 Continuous printing Weighing data are issued
continuously (every 230 ms).
D05 Single transmission of data Identical to PRINT key
D06 Automatic output at printer See the respective settings in AUTO
PRINT.
D07 Single output of data with
stability information
The data are issued with
S: If stability indicator is displayed
U: If adjusted without stability
D08 Single output of data with
stability status
Data output after transmission of
command
D09 Output stop
UTO PRINT finishes and the
output
Q ON/OFF Standby and weighing status
T Tare See the respective settings in TARE
key.
TS Wait for stable tare Tare is performed after standby.
CAL Setting
R Restart Reset
To Next Page
Loading...
Need help?
General
