To Next PageTo Next Page
Need help?Do you have a question about the KERN CME 100-3 and is the answer not in the manual?
Defines correct usage and highlights improper actions to avoid.
Details warranty void conditions and the importance of monitoring test resources.
Stresses reading the operation manual and requiring trained personnel.
Instructions for checking the appliance upon receipt and retaining packaging.
Guidelines for choosing an optimal location for the balance.
Steps for unpacking and identifying included accessories.
Details assembly steps for the optional tripod accessory.
Covers mains connection and optional battery power for the balance.
Guidelines for connecting external devices like printers or PCs.
Steps for bringing the balance to operating temperature and initial setup.
Explains the necessity of adjustment and provides step-by-step calibration instructions.
Introduces the balance display layout and function of each key.
Explains basic weighing, taring, and PRETARE functions.
Covers plus/minus weighings, parts counting, and percent weighing.
Instructions for entering and leaving the balance's menu system.
Lists available menu functions and provides brief descriptions.
Details configurable parameters like baud rate, auto-off, and zero-tracking.
Describes how to switch between different weighing units.
Details options for controlling the display's background illumination.
Explains how to configure auto-zero and zero-tracking functions.
Guides on selecting appropriate adjustment weights for calibration.
Procedure for resetting the balance to its default factory configuration.
Specifies technical details and pin assignments for RS 232 C interface.
Covers setting up data transfer mode and baud rate.
How to select data output formats for printing.
Instructions for outputting data to a Zebra LP2824 bar code printer.
Guidelines for safely cleaning the balance.
Information on authorized service personnel and power disconnection.
Instructions for proper disposal of packaging and the appliance.
Provides steps for common faults like no display or incorrect readings.
Advice on dealing with other error messages and contacting support.
Explains the dual balance assembly for piece counting.
Presents technical specifications for the counting system components.
Lists the components that make up the counting system.
Covers connecting scales and configuring settings for automatic transfer.
Step-by-step guide on using the CDE and CME scales together for counting.
General
