KERN CXB 3K0.2 - Call-Up; Count with Tolerance Control - Fill to Target; Set Tolerance Value for Target Number of Pieces

CXB/CXP-BA-e-1016
29
9.4.2 Call-up
When the reference weight is required at a later point in time it can be called by
pressing the key and entering the relevant storage location number.
Press button
PlSET
W
a
PRE-
TARE
M+
W
Enter memory location (0 - 9) via number keys and the stored reference weight will
appear.
0.0
a
PRE-
TARE
W
100
0
M+
W
9.5 Count with tolerance control - Fill to target
This function can be used to program a target number of pieces or target weight.
Reaching the target value is indicated by an audio-visual signal.
9.5.1 Set tolerance value for target number of pieces
[ -0.TX- ] is flashing in reference weight window.
Press button
-----
a
PRE-
TARE
0
300
M+
W
Last value stored
Use number keys to enter desired target number of pieces
-----
a
PRE-
TARE
100
Entered target value.
Corrections possible by
pressing key
300
M+
W
Last value stored