KERN EOC User Manual

EOC-BA-e-1920 7
KERN EOC 60K-2 EOC 60K-2L EOC 60K-3
Readability (d) 10 g / 20 g 10 g / 20 g 1 g / 2 g
Weighing range (max) 30 kg / 60 kg 30 kg / 60 kg 30 kg / 60 kg
Reproducibility 10 g / 20 g 10 g / 20 g 1 g / 2 g
Linearity ± 30 g / 60 g ± 30 g / 60 g ± 3 g / 6 g
Warm-up time 10 minutes 10 minutes 2 hours
Minimum unit weight at
piece counting under
laboratory conditions*
2 g 2 g 2 g
Minimum unit weight at
piece counting under
normal conditions**
20 g 20 g 20 g
Reference unit weights at
piece count
10, 20, 50, 100, 200
Weighing Units Details „Weighing units“ chapter 7.6
Recommended adjustment
weight, not added (class)
Details for „Selection of
the Adjustment weight“
in chapter 7.6
60 kg
(M1)
60 kg
(M1)
60 kg
(M1)
Stabilization time (typical) 2 sec.
Electric Supply
100 V - 240 V, 50 / 60 Hz
Auto Off
off, 3 min., 5 min., 15 min., 30 min.
Operating temperature - 10° C .... + 40° C
Humidity of air max. 80 % (not condensing)
Terminal (B x D x H) mm 268 x 115 x 80
Platform (B x D x H )mm
300 x 300 x 110 500x400x120 300 x 300 x 110
Weight kg (net) 5.2 9.0 5.2

KERN EOC Specifications

General

Brand	KERN
Model	EOC
Category	Scales
Language	English

Summary

Technical Data Specifications

General Information and Usage Guidelines

Proper Balance Usage

Describes the intended and correct method for operating the balance for accurate weighing.

Improper Use and Restrictions

Outlines incorrect operational practices that could damage the balance or yield inaccurate results.

Essential Safety Precautions

Adhering to Operation Manual Instructions

Emphasizes the importance of carefully reading the manual before operation and setup.

Qualified Personnel Operation

States that only trained personnel should operate and maintain the appliance.

Unpacking, Setup, and Commissioning Guide

Optimal Installation Site Selection

Details factors for choosing the best location for accurate and fast weighing operations.

Mains Power Connection

Initial Balance Commissioning

Balance Calibration Procedure

Detailed Adjustment Process

Linearization for Improved Accuracy

Operating the Balance

Balance Start-up Procedure

Instructions for powering on the balance and preparing it for weighing.

Zeroing the Balance Scale

Details how to reset the balance to zero using the automatic zero setting function.

Performing Simple Weighing

Weighing Operations with Tare Function

Weighing with Tolerance Limits

Tolerance Check for Target Weight

Tolerance Check for Target Quantity

Performing Parts Counting

Percentage Weighing Function

Calibration and Linearization Settings

Balance Error Messages and Descriptions

Instant Help for Common Faults