CB/FCB-BA-e-0640
23
8.2 Leave menu structure
Everywhere in the menu it is possible to leave the menu structure and thereby save
or reject the changes made.
After pressing the key „Exit“ is displayed.
A : Use the (YES) key, to confirm. After that „store“ is displayed. If it shall be
saved, press the key repeatedly.
If the menu shall be left without saving,
press the NO key.
B : The (NOT EXIT) key must be pressed, if the next menu item shall be
reached. After having set all the individual adjustments, it can be saved.
8.3 Dosing and Zero-tracking
The Auto-Zero function is used to tare small variations in weight automatically.
In the event that small quantities are removed or added to the material to be
weighed, incorrect weighing results can be displayed due to the “stability
compensation“ in the balance. (Example: Slowly draining fluids from a container on
the balance).
When apportioning involves small variations of weight, it is advisable to switch off this
function.
If Zero-Tracking however is switched off, the weighing display becomes more busy.
Activate/deactivate Zero-Tracking Balance display
1. Keep the key pressed until „Unit" is displayed.
Unit
2. Press the key several times until „tr“ is displayed.
tr
3. Press the key to activate the function.
tr on
4. By pressing once more the key, the function is
deactivated.
tr off
5. The changed setting is taken over by pressing
the key.
6. The balance returns to the weighing mode. 0.0 g
To Next Page
Loading...
Need help?
General
