MLB50-3-BA-defsi-0310
53
10.2 Changing languages
Use the main switch to switch the balance on.
The balance starts up using the language last selected.
To change languages switch the balance off and on again.
The balance displays the “PAs ??“ software version, followed by “tEst“ for a few
seconds. Press the key whilst “tEst“ is being displayed.
Either “Lan En“ for English or “Lan dE“ for German will appear on the display
screen to set the balance.
Use the key to change between the languages.
Use the key to accept the setting.
“EntEr“ will now appear on the display screen. Use the key to confirm the set-
ting. The balance will run through a ”tEst” mode. “0.000“ will appear on the display
screen after a few seconds.
11 Maintenance, upkeep, disposal
11.1 Cleaning
Please disconnect the device from the operating voltage before cleaning.
Only use a cloth dampened with mild suds and not aggressive cleaning agents (sol-
vents or similar). Please ensure that fluids are not able to get into the device and rub
off using a clean, soft cloth.
Loose sample residue/powder can be removed carefully using a brush or hand vac-
uum cleaner.
Remove any spilt material to be weighed immediately.
11.2 Maintenance, upkeep
The device may only be opened by trained service engineers authorised by KERN.
Disconnect from the mains supply before opening.
11.3 Disposal
The operating company shall dispose of the packaging and the device in compliance
with the valid national or regional law of the operating location.
To Next Page
Loading...
Need help?
General
