Kernel Multi Check - Changing the Unit of Measurement

To Next Page

To Previous Page

3. Insert batteries and slide battery cover back.

The Batteries Installation

NOTE:

Your meter comes with two AAA size batteries (1.5V).

Changing the Unit of Measurement

1. Slide battery cover off the back of the meter and remove batteries.

There is a unit-changing switch in battery compartment. Use a screwdriver to adjust the

switch.If you push it up,the glucose,cholesterol and hemoglobin unit changes to mmol/L;

the uric acid unit changes from mg/dL to μmol/L. If you pull it down, the glucose, cholesterol

and uric acid unit is mg/dL ; the hemoglobin unit is g/dL.